Fabrication of basalt embedded composite fiber membrane using electrospinning method and response surface methodology

Abstract

AbstractIn this study, a novel basalt embedded fiber membranes was prepared by the electrospinning method. The effects of the feed rate, voltage, tip to collector distance, and the basalt content on the prepared composite fiber membranes were investigated and optimized using the response surface method. Four models were built to compare the fibers in terms of deionized water flux (DWF), activated sludge flux, chemical oxygen demand (COD) removal, and porosity of fiber membranes. All the developed models were significant and adequately precise. The maximum flux of DWF was obtained when the voltage was 17.25 kV, the tip to collector distance of 19 cm, and a basalt content in polymer of 1.25%. COD removal decreased at higher voltage values as the feed rate increased. The porosity, pore size, and the contact angle values decreased for basalt embedded fiber membrane. The increases in the basalt percentage in polymer increased the hydrophilicity of the fiber. The flux decline for the basalt embedded fiber membrane was compared with the pristine fiber membrane. The permeate fluxes of pristine and basalt embedded fiber membranes were 42.3 and 59.6 L/m2/h, respectively. The biofouling performances of pristine and basalt embedded fiber membranes were also examined. Irreversible fouling decreased from 42.9% to 8.0%, and reversible fouling increased from 56.5% to 91.1% after modification of the membrane with basalt powder. Scanning electron microscopy with energy dispersive X‐ray analysis (SEM–EDX) analysis showed that basalt powder was successfully embedded into polyether sulfone polymer.