Abstract
AbstractZn‐air battery is a promising next‐generation energy storage device. Its performance, however, is limited by a high overpotential resulted from the slow kinetics of the cathodic oxygen reduction reaction (ORR). This study reports a simple strategy for preparation of a fluorine‐doped Co−N−C composite as highly efficient electrocatalyst for ORR. The C@PVI‐(TPFC)Co‐800 catalyst was prepared by pyrolysis of F‐containing Co‐corrole that was assembled on PVI‐functionalized carbon black through the axial imidazole coordination (PVI=polyvinylimidazole, TPFC=5,10,15‐triperfluorophenyl‐21H, 22H‐corrole). The C@PVI‐(TPFC)Co‐800 catalyst exhibited much more positive ORR half‐wave potential (E1/2=0.88 V vs. RHE) than its counterpart C@PVI‐(TPC)Co‐800 (E1/2=0.82 V, TPC=5,10,15‐triphenyl‐21H, 22H‐corrole) without F‐doping in 0.1 M KOH electrolyte. C@PVI‐(TPFC)Co‐800 also achieved a greater kinetic current density and enhanced durability in alkaline media. In addition, a Zn‐air battery with C@PVI‐(TPFC)Co‐800 loaded at the cathode delivered much higher peak power density (Pmax=141 mW/cm2) and open‐circuit voltage (OCV=1.45 V) over the C@PVI‐(TPC)Co‐800 counterpart (Pmax=110 mW/cm2, OCV=1.39 V) and the commercial 20 % Pt/C (Pmax=119 mW/cm2, OCV=1.42 V) as well. The promoted catalyst performance for ORR was attributed to the increased specific surface area, more defects generated, and reduced electron density distribution around the Co metal center after F‐doping.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.