Abstract
This paper presents an experimental investigation on the metal components fabricated by laser cladding. In the present study, two process of laser cladding were conducted, that is pre-placed powder cladding and coaxial powder-feed cladding. The effect of processing parameters was studied and optimum set of parameters for the superior surface quality was established by employing the orthogonal design. The fabricated components were subjected to metallographic examinations and micro-hardness measurement. Results indicated that the microstructure of coaxial cladding components was finer than pre-placed powder cladding components. The micro-hardness of the fabricated specimen along and vertical the scanning direction were measured using a HVS-1000 micro-hardness tester with a 200 g applied load. Analysis of the physical properties provided further evidence of differences in micro-hardness produced by different process conditions, and the average micro-hardness value of pre-placed power cladding layer was lower than the coaxial powder-feed cladding layer.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
