Abstract
Abstract: The influence of process factors and the integrity of the surface roughness are investigated experimentally in the current study on the metals Al6061 and Al2024. In order to conduct vertical cutting tests for both base alloys, a mixed level L9 orthogonal array is used. An optical emission spectrometer is used to analyse the chemical composition. SEM is used to analyse the microstructure of the materials used to discover tiny inertinitic precipitates in an aluminum matrix using ANOVA Table value. Mild steel was the tool employed, and surface topography and 2D roughness profile data were used to assess the surface integrity of cut surfaces. The experimental trials with various degrees of process parameters, such as Taguchi L9 orthogonal array. In determining surface roughness, speed, feed, and depth of cut are determined to be the most important variables.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal for Research in Applied Science and Engineering Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
