Experimental investigation into corrosion effect on buckling and low-cycle fatigue performance of high-strength steel bars

Abstract

The reinforcement in marine RC structures will inevitably be corroded under long-time erosion of chloride ions, which will weaken steel mechanical properties and then structural seismic resistance. The new metallurgical technology is adopted for manufacturing high-strength steel bars (HSSB), but that may affect the corrosion resistance of steel bars at the same time. This paper experimentally investigates the effects of corrosion on monotonic and low-cycle fatigue properties of HSSB HTRB600 and normal strength steel bars (NSB) HRB400E. The HRB400E and HTRB600 steel bars were corroded to different corrosion rates by electrochemical accelerated corrosion technique. The monotonic tensile and compressive, as well as low-cycle fatigue tests of corroded steel bars were conducted to investigate the effects of corrosion on steel mechanical properties, of which corrosion levels (0–20% target corrosion mass loss), slenderness ratios (L/D=6, 8, 10, 12) and strain amplitudes (2%, 4%) are considered. Test results show that, the corrosion morphology of steel bars under electrochemical accelerated corrosion is basically consistent with that observed under natural corrosion. Compared with uncorroded HRB400E and HTRB600 steel bars, 20% corrosion mass loss leads to 38% and 35% decrease in tensile strength, as well as 33% and 28% reduction in buckling stress, respectively. The HTRB600 steel bars present slightly superior monotonic tensile and compressive corrosion resistance than HRB400E steel bars. Corrosion obviously decreases the low-cycle fatigue (LCF) life of steel bars, resulting in reductions of 44% and 36% in LCF life at 20% corrosion mass loss for HTRB600 and HRB400E steel with a L/D of 6, respectively. Moreover, the HTRB600 steel bars present more significant corrosion degradation in total hysteretic dissipated energy, compared with HRB400E steel bars. The combined effect of corrosion and inelastic buckling further exacerbates the deterioration of LCF performance of steel bars. The corresponding deterioration models are proposed to determine the LCF life and energy dissipation capacity of corroded steel bars.