Abstract
A local heat transfer coefficient (HTC) has been determined for six cases of vertical plates cooling by the water-air assisted sprays. Full cone 60° nozzle operating under pressure of 0.1, 0.25 and 0.4 MPa has been employed. The plates have been made from the Inconel alloy and stainless steel. The Inconel alloy differs to some extend in thermophysical properties from stainless steel. Plate temperature has been measured with thermocouples at 25 points distributed over 1/4 of the cooled surface. The inverse solutions have given HTC as function of surface coordinates and time. The HTC maximum has varied from 3 to 10 kW/(m2∙K) over water stream zone. The critical heat flux ranging from 600 kW/m2 to 2.5 GW/m2 has been obtained depending on pressure, location and plate material. Based on a large set of HTC a model of local HTC as function of pressure, surface temperature and distance from the stagnation point has been developed. The HTC model depends on 15 coefficients which has been determined for Inconel and stainless steel. The HTC model has been validated. Energy extracted from the plate surface and temperature distributions predicted by the model have been compared to data obtained from inverse solutions and temperature measurements. It has been concluded that the model accuracy is sufficient for simulations of water spray cooling of low conductivity steels from 1200 °C to 50 °C.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
