Abstract
This study intends to establish the behaviour of equal leg single-angles under bi-axial bending and compression experimentally and analytically using nonlinear finite element analysis techniques. In the experimental system, 100×100×10 nominally sized equal leg single-angles were tested. The legs of angles were placed in a flange-down position, and their axes were restrained laterally as a simply supported beam. These simply supported beams were loaded with a concentrated vertical load applied at the middle of the length and an axial load parallel to the beam axis until failure was reached. The FEM model of the experimental system was generated with ABAQUS software. Suitable finite element mesh configurations, boundary conditions and nonlinear analysis solution techniques were determined to identify the system behaviour. The test and ABAQUS software results were interpreted using some code specifications and one design procedure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.