Abstract
By using experiment cutter edge topography obtained by super depth three-dimension microscope, fits the cutter edge curve and calculate experiment cutter edge radius value; by high speed milling hardened steel experiment, individually researches cutter edge and cutting parameters influence on machined surface in high speed milling hardened steel with end-milling cutter and ball-end milling cutter. The experiment analysis results show that under the same cutting parameters condition, machined surface roughness in high speed end-milling cutter milling is better than in high speed ball-end milling; within experiment selected cutting parameter range, cutter edge radius is the main influence factor on machined surface roughness in high speed end- milling hardened steel, while the influence on machined surface roughness in high speed ball-end milling hardened steel is not obvious. In end-milling, when edge radius and milling depth are in the same order magnitude or the difference is not obvious, milling depth should be a little bigger than selected cutter edge radius value.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
