Abstract
Problems with corrosion in boilers and their parts can be solved by the application of different nickel alloys like 622, 625 or 686 by a variety of welding processes. This solution is used mostly in Waste-to-Energy plants or biomass stations burning waste wood, but it can also be found in the recovery boilers used in the paper industry. The most common material grades include low alloyed boiler steels like 16Mo3, 13CrMo4-5 and 10CrMo9-10. When there is a need to increase steam temperature and pressure more complicated alloys to become a natural choice. This paper focuses on the fabrication experience of welding of 7CrMoVTiB10-10 base tube with Inconel 625 weld overlay and presents a welding solution of matching filler metal used for root pass and S Ni 6625 filler metal for a fill-up and the cap performing a full strength weld without the need of overlay peeling and manual tie-in overlay. This method of welding saves a lot of time during execution in the workshop and on-site during installation and assures much better quality in the end. All examinations were performed to allow welding procedure qualification according to ASME and EN standards.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
