Abstract
The excess noise factor(F) is an important parameter for Avalanche Photodiodes (APDs), indicating the extent to which the noise of the diodes exceeds what it would be without multiplication. This paper presents a method of measuring the excess noise factor for high-speed low-noise APDs using the high-sensitivity spectrum analyzer. The F factor test for the high-speed low-noise APDs was performed by comparing two conditions with and without illumination to remove the interference of the system, including the thermal noise and analyzers. The setup conditions of the light source are analyzed in detail. The F factor was obtained as 3.03 when the multiplication factor M is 10, which corresponds to an effective ionization coefficient ratio k of 0.14 for the high-speed InAlAs APD. For comparison, the k value of a commercial Si APD is tested to be ∼0.06.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
