Abstract
The positive effects of deep cryogenic treatment on the wear resistance of cutting tools and workpiece material are well known; however, no information has been reported about the effect on the machinability of cryo-treated tool steel in hard turning. In order to investigate the effects of cryogenic treatment on the machinability of hardened and cryo-treated tool steel, a number of investigations were performed on the hard turning of cryo-treated AISI H13 hot-work tool steel with two ceramic inserts under both dry and wet cutting conditions. Three categories of the hot-work tool steel were turned in the machinability studies: conventional heat treated (CHT), cryo-treated (CT) and cryo-treated and tempered (CTT). Experimental results showed that the lowest wear and surface roughness (Ra) values were obtained in the turning of the CTT samples. Additionally, in terms of main cutting force (Fc), surface roughness (Ra) and tool wear, Ti[C, N]-mixed alumina inserts (CC650) showed a better performance than SiC whisker-reinforced alumina inserts (CC670) under both dry and wet cutting conditions. The use of cutting fluid slightly improved the machinability of the tool steel.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Refractory Metals and Hard Materials
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
