Abstract
The low back pain risks in a beef skinning operation at a high stand kill floor workstation was evaluated. The increases in compressive forces at lower back (L5/S1) between normal slump (back angle 25°, measured in the sagittal plane) and severe (45°) and between normal slump and very severe (70°) bent back postures were 387 N or 28% and 616 N or 45%, respectively. The high spine load coupled with high level of repetition can have a high probability of fatigue failure in the spine structural members. Non-neutral back posture for a large portion of the total work time can be a low back pain risk factor. The videotape analysis showed that the times involved during the task performance for the bent back (more than 25°) and severe bent back (more than 45°) were 48.4 and 33.5% of the total cycle time, respectively. The upper limit from OWAS (Ovako Working Posture Analysis System) for bent back posture is 30% of the total cycle time. The bent and twisted back posture (both more than 25°) time was 10.4% compared to OWAS limit of 5%. This indicated that actions are needed in the near future to alleviate the risk of low back pain. Ergonomics redesign of the workstation was recommended for the operation.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Occupational Safety and Ergonomics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
