Abstract
The issue of excessive wear of shaft journals co-working with a rubber bearing has been unexplained so far. Premature and sometimes very intensive wear of ship sliding bearings in water conditions is the reason for carry out very expensive and more frequent than expected repairs. The authors (E. Piątkowska, W. Litwin) made an attempt to find a case that influences the value of this wear described in the paper “Attempt at Evaluating the Influence of Bending Stress on Shaft Wear Process in Water Lubricated Sliding Bearing with Rubber Bush” (TRIBOLOGY 1/2017). These studies, however, did not explain the dependency of the wear process but showed how to progress further to find the answer to the question about the effect of bending stress on shaft wear. The research is continued on a modified test stand, and their results are presented in this paper. The profilographometer was used to evaluate the wear of the journal shaft. To compare wear intensity, roughness profiles have been 'removed' from the journals both before and after co-operation. They were compared in terms of bending stresses and bending moments.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
