Abstract

Polymer consumption is increasing and the recycling rate is 30–40 wt.%. Thus any process or application that uses recycled plastic residue will be looked upon with favor. It has been demonstrated that post-consumer commingled polymer, or PCCP, coatings can be produced by thermal spraying. Furthermore, polymeric coatings are widely used as protective coatings against solid particle erosion. Therefore, in this paper the erosion behavior of thermal spray coatings that have some PCCP material is investigated. The coatings were produced using a low velocity combustion thermal spray process and a PCCP mixed with different levels of virgin ethylene–methacrylic acid co-polymer (EMAA). The erosion rates using 50 μm alumina were determined at impact angles of 30° and 90°. The wear features were analyzed by scanning electron microscopy and profilometry. The results exhibited brittle wear features, consistent with the relationship between erosion rates and mechanical properties of the polymers. However, a decrease in erosion rate with an increase in impact angle, from 30° to 90°, indicates ductile behavior during erosion.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.