Equivalent diffusion coefficient of clay-rich geological formations: comparison between numerical and analytical estimates

Abstract

Laboratory experiments in rock samples collected from clay-rich formations indicate that the effective molecular diffusion coefficient (D) is a heterogeneous and anisotropic property. Since laboratory measurements of D are representative of a very small volume, upscaling is necessary in order to incorporate these data in large-scale numerical models of diffusive transport. In this work we address the problem of the estimating the equivalent diffusion coefficient (D eq ), in terms of total diffusive flux, in a three-dimensional domain characterized by a heterogeneous and anisotropic spatial distribution of D. D eq was estimated from the results of steady-state diffusive transport simulations through several realizations of the D field. The ensemble averages of D eq from fields with different degrees of heterogeneity and anisotropy were then compared with estimates from analytical upscaling expressions based on stochastic as well as power-averaging approaches. These expressions are largely based on similar expressions developed for calculating the effective hydraulic conductivity in heterogeneous and anisotropic domains. Comparisons showed that stochastic expressions provide accurate estimates of D eq only for fields characterized by low heterogeneity. Within the range of heterogeneity and anisotropy considered, our results showed that a power-averaging expression is very accurate in predicting D eq especially when the parameter p i is estimated through fitting of the numerical results. Nonetheless, the relationship between this parameter and the anisotropy ratio is linear.