Abstract
The enhancement in thermoelectric (TE) properties of p-type SiGe alloys through the optimization of carrier concentration and processing parameters was reported. The p-type Si80Ge20Bx alloys were prepared by melt spinning (MS) followed by spark plasma sintering (SPS). The effect of B concentration and processing parameters (rotating speed of Cu wheel in MS and holding time in SPS) was investigated. By adjusting the B content, the carrier concentration was notably changed but the carrier mobility was not significantly different. Consequently, TE properties were varied with B concentration and showed the optimum value for Si80Ge20B0.5 with the maximum ZT of 0.71 at 1073 K. Increasing the Cu wheel rotating speed resulted in the refined microstructure of the MS ribbons. The smaller grain sizes were maintained even after SPS. However, despite the refined grains, the TE properties were insignificantly different for any rotating speed. Reducing the SPS holding time resulted in bulk samples with lower density, presumably containing nano/micro porous structure. The presence of pores in the microstructure effectively reduced thermal conductivity due to a stronger phonon scattering, but also suppressed the electrical contribution making an obvious drop in the power factor. The optimized holding time for SPS was 5 min at 1323 K.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
