Abstract

Blends of Jatropha Curcas oil and standard diesel fuel were evaluated (without pre-heating). The engine tests for the blends were performed in a Petter single cylinder direct injection diesel engine under steady state conditions at high loads. Engine speeds between 1300-1700 rpm were selected for the engine tests. Torque, power output, specific fuel consumption, in cylinder pressure, ignition delay, rate of heat released and exhaust composition were evaluated. The tested blends between 10-20% of oil shown lower effective torque and power output joint to a higher specific fuel consumption related to the lower heating value of Jatropha oil compared to diesel fuel. Lower pressure peaks and rates or pressure rises were observed when Jatropha blends are used. A decrease in the rate of heat released and shorter ignition delay were observed for the blends. Decreases in HCand CO emissions were observed for blends compared to diesel fuel. Both alternatives assessed shown that the differences observed compared to diesel fuel, can be partially restored with engines regulation. The use of Jatropha oil in order to be a partial or full alternative to the use of diesel fuel for energy production was achieved.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.