Abstract
Part 1 presents a theoretical solution to the problem of lubrication of soft, highly deformed surfaces. It is argued that with this type of contact the inlet and outlet regions can be separated and analysed independently. This approach leads to a single value of non-dimensional film thickness at the point of maximum contact pressure and to a non-dimensional minimum film thickness dependent on the relationship between the inlet and outlet parameters. In Part 2, these results are applied to the problems of a cylinder sliding on an elastomer lined surface, an elastomer lined journal bearing and a sliding O-ring seal.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.