Effects of vitrification on the viability of alginate encapsulated isolated bovine pre-antral follicles.

Abstract

Individual follicle cryopreservation techniques, without hydrogel support, are labor-intensive and a substantial proportion of isolated follicles are lost during handling and after warming. Therefore, the viability and morphology of isolated bovine (as a model for human) pre-antral follicles after vitrification and warming, when encapsulated in alginate beads, were investigated. Bovine pre-antral follicles were mechanically isolated and divided into four different groups: (1) culture in 2% alginate beads (3D system) and vitrification in beads using mesh cups (3DVIT), (2) culture in 2% alginate beads (3DCUL), (3) culture in 96-well plates (2D system) and vitrification using High Security Vitrification straws® (2DVIT), (4) culture in a 2D system (2DCUL). The same vitrification and warming protocols were used for embedded (3DVIT) and non-embedded follicles (2DVIT). No differences were observed in follicle viability between group 2DCUL and 3DCUL. Group 3DVIT showed the lowest viability (45.9%) according to calcein and neutral red staining among all groups. Group 2DVIT displayed the highest viability (87.5%) and largest percentage of follicles with a well-preserved morphology. Our results show that, using a vitification protocol optimized for non-embedded follicles, 2D culture is more effective in vitrifying isolated follicles. However, embedding in alginate allow to handle follicles more efficiently, i.e., without excessive manipulation and thus less labor-intensive in combination with a reduced loss of follicles during the procedure. Based on the increased work efficiency, but lower viability and higher proportion of follicles showing impaired morphology, we consider it advantageous to optimize the protocol for the vitrification of embedded follicles to increase survival and maintain morphology after vitrification.