Abstract
AbstractLattice structures are very interesting since they present good mechanical properties coupled with lightness. Today, the maturity reached by additive manufacturing technologies allows the production of such structures. However, the mechanical properties of the constituting material can be affected by the process itself, because of the particular geometry. In fact, in a previous work, the mechanical characteristics of the bulk‐printed material were used for modelling the bending behavior of lattice‐cored specimens made of Ti6Al4V and produced through electron beam melting (EBM) process, but a certain discrepancy with experimental results was found. Therefore, in this work, a procedure was proposed to determine the mechanical properties of the material the lattice specimen is made of, in order to reduce the gap between the numerical and the experimental results. By considering the redetermined yield strength, such mismatch was reduced. Moreover, the metallographic analysis of the material found that the α laths of the α + β microstructure, typical of the studied alloy, were thinner than those of bulk specimens, and the presence of α′ martensite was discovered too. The fracture surface analysis determined a ductile failure mode for the lattice core while a fragile mode for the skins.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Fatigue & Fracture of Engineering Materials & Structures
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
