Abstract
A chimney dependent solar crop dryer (CDSCD) was developed and studied. Design of Experiment (DOE) was employed using statistical three level non randomized factorial experimental design in Minitab statistical software version 19.0. The study of effects of roof angle, inlet gap size and dryer height on dryer temperature revealed that the height at which the drying tray is positioned (A) and the inlet gap (C) influences the highest temperature difference, 30.4 °C. It was concluded that dryer temperature is high when the inlet gap is small (range of inlet area to exit area ratio of 1.8128:1 to 1.0877:1) and the maximum ratio of height of dryer to drying tray’s position is 2.18. Optimal values for achieving high temperature difference response greater than or equal to 32.6 °C are minimum roof height of 84 cm, inlet to outlet area ratio of 1.0877:1 and minimum roof angle of 81°. The effect of the three parameters on relative humidity revealed that the combined effect of roof angle and inlet gap (AB) attained the highest standardized effect of 6.6. The optimal values for achieving low dryer relative humidity (when loaded with 1 kg of cassava) were roof angle of 64°, inlet to outlet area ratio of 2.5379:1 and minimum time of 19 hours. This could serve as effective tool for comparing different designs of CDSCD dryers for optimum humidity and drying performances and be used to subsequently refine solar crop dryer design.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
