Abstract
Granular particles formed on a CuInSe2 (CIS) thin film surface with alkali-halide RbF post-deposition treatment (RbF-PDT) are found to concentrate preferably on other than smooth (112)-planes present on the CIS film surface. As a consequence, a large number of distinctive pores are selectively formed at relatively rough facets. Although the open circuit voltage and fill factor values of CIS solar cells improve with either RbF-PDT or heat-light soaking (HLS) treatment, the effects of these treatments are distinguishable. The ratio of carrier recombination rates at the interface (Ri) to that in the bulk (Rb), namely, Ri/Rb, decreases with RbF-PDT. HLS treatment performed on RbF-PDT CIS devices leads to a further decrease in the value of Ri/Rb, whereas the value of Ri/Rb of CIS devices fabricated without RbF-PDT increases with HLS treatment. Ternary CIS solar cells grown with RbF-PDT and HLS treatment reproducibly demonstrate enhanced photovoltaic efficiencies.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
