Effects of pin diameter and number of cycles on microstructure and tensile properties of friction stir fabricated AA1050-Al2O3 nanocomposite

Abstract

Nanocomposites of Al-Al2O3 are fabricated by means of friction stir processing (FSP). Effects of pin diameter and number of FSP cycles on tensile properties of the nanocomposites are investigated and the variations are correlated to the evolution of microstructure and distribution of nanoparticles in addition to agglomeration of Al2O3 nanoparticles. Investigation of agglomeration has been considered as an indirect indication for efficiency of the process for distribution of nanoparticles. The ductility of the nanocomposite is found to improve due to grain refinement during FSP. However, the ductility is likely to degrade if Al2O3 particles agglomerate and form coarse particles. The composite fabricated using the 6-mm pin indicates the maximum ductility which is attributed to formation of fine grain structure and efficient distribution of nanoparticles in the composite. Although, the grain structure in the composite fabricated using 8-mm pin is well refined, this sample shows significantly lower ductility with respect to the other samples. This was attributed to formation of coarse agglomerated particles. The second pass of FSP is found to slightly improve ductility and strength in composites fabricated using 4- and 6-mm pins but enforce significant improvements in the one with 8-mm pin. This is indeed because the second pass results in significant change in the distribution of nanoparticles or agglomerated particles in the latter case and negligible in the former ones. Grain structure and nanoparticle distribution and agglomeration can all affect the fracture surface of the tensile specimens of the fabricated nanocomposite to be ductile or brittle.