Effects of pH on the Textural Properties and Meltability of Pasteurized Process Cheese Made with Different Types of Emulsifying Salts

Abstract

Functional properties of pasteurized process cheese (PPC) made with different types of emulsifying salts (ES) (2%, wt/wt) were investigated as a function of different pH values (from 5.3 to approximately 5.9). The ES investigated were trisodium citrate (TSC), disodium phosphate (DSP), sodium hexametaphosphate (SHMP), and tetrasodium pyrophosphate (TSPP). Meltability and textural properties were determined using UW-MeltProfiler and uniaxial compression, respectively. All PPC samples exhibited an increase in degree of flow (DOF) determined at 45 degrees C when the pH was increased from 5.3 to 5.6, presumably reflecting greater Ca binding by the ES, increased charge repulsion and therefore greater casein dispersion. When the pH of PPC was increased from 5.6 to approximately 5.9, 2 types of ES (DSP and SHMP) exhibited no further increase in DOF at 45 degrees C; while DOF increased in 1 type of PPC (made with TSC) but decreased in another (made with TSPP). TSPP is able to form crosslinks with casein especially in the vicinity of pH 6, which likely restricted melt; in contrast TSC does not crosslink caseins and the increase in pH helped cause greater casein dispersion. Low pH samples (5.3) were not significantly harder than higher pH samples for all ES types but exhibited fracture. The PPC with the highest hardness values at pHs 5.3 and 5.6 were made with TSPP and TSC, respectively. The pH-dependent functional behavior of PPC was strongly influenced by the type of ES and its physicochemical properties including its ability to bind Ca, the possible creation of crosslinks with casein and casein dispersion during cooking.