Abstract
Adaptive antennas are now used to increase the spectral efficiency in mobile telecommunication systems. A model of the received carrier-to-interference plus noise ratio (CINR) in the adaptive antenna beamformer output is derived, assuming that the weighting units are implemented in hardware, The finite resolution of weights and calibration is shown to reduce the CINR. When hardware weights are used, the phase or amplitude step size in the weights can be so large that it affects the maximum achievable CINR. It is shown how these errors makes the interfering signals leak through the beamformer and we show how the output CINR is dependent on power of the input signals. The derived model is extended to include the limited dynamic range of the receivers, by using a simulation model. The theoretical and simulated results are compared with measurements on an adaptive array antenna testbed receiver, designed for the GSM-1800 system. The theoretical model was used to find the performance limiting part in the testbed as the 1 dB resolution in the weight magnitude. Furthermore, the derived models are used in illustrative examples and can be used for system designers to balance the phase and magnitude resolution and the calibration requirements of future adaptive array antennas.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Aerospace and Electronic Systems
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
