Abstract
The main goal of this study was to control the fouling phenomena in MBR using chemical additives. In the first phase of the study, SMP removal and bound EPS formation capacity of chemical additives were determined. Highest SMP removal (72%) was achieved by the Poly-2 additive. In the second phase of the study, short term filtration tests were conducted. Poly-1 exhibited highest performance based on membrane resistance, permeability and average TMP. According to the results obtained from constant shear rate tests in fourth phase, no significant change in viscosity with time was observed. Studies for the adaptation of rheograms to common flow models showed that chitosan and starch was not able to fit to Ostwald de Waele and Bingham models. At a shear rate of 73.4s−1 viscosities of all samples were close to each other. Chitosan and starch achieved highest viscosity values at the shear rate of 0.6s−1.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
