Abstract
Wear reduces velocity and turbulence by reducing the volume of impeller blades; yet there is a lack of knowledge on flotation cells. Additionally, there is a lack of knowledge in the literature regarding the effect of blade wear on bubble–particle interactions. Hence, computational fluid dynamics simulations investigated artificial impeller blade wear of a laboratory–scale Denver cell. Simulations of chalcopyrite flotation showed that blade wear increased floatability of 10 μm particles by 1.4 %, but decreased that of 180 μm particles by 3.0 %. Accordingly, it is proposed that curved surfaces due to wear increased ε (volume–averaged ε [m2/s3]: no–wear 20.5 and wear 25.8), increasing collision of fine particles and detachment of coarser particles. These were supported by results from large eddy simulation and particle image velocimetry measurements using three–dimensional (3D) printed impellers. Finally, experimental results from flotation experiments using 3D printed impellers and 250–300 μm methylated quartz confirmed a floatability decrease (2.1 %–3.8 %) due to wear.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
