Abstract
The paper presents a description of a modern direct screw drive carried out by a torque motor of a torque 300 Nm, maximum rotational speed 500 rpm and power 15.7 kW. The operation of the torque, its advantages and disadvantages were described. In the extruder plasticizing system in the feed opening zone and part of the feed zone, an exchangeable smooth sleeve and a grooved sleeve with 6 or 8 longitudinal grooves were used. For research, low density polyethylene of the commercial name Malen E and symbol FGNX 23-D006 was used. In the extruder barrel, a special screw was mounted 25 mm in diameter and L/D = 24, with elements of intensive shearing and mixing, constructionally adapted to the grooved section. The research was conducted in the wide range of rotational screw speeds from 1.67 to 8.33 rps.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
