Abstract
The interfacial reaction between Sn–36Pb–2Ag (numbers are all in mass% unless specified otherwise) solder balls and Ni, Ag and Ni/Ag electroplated on a Cu substrate was investigated and the joint bonding strength was measured using a ball shear tester. The intermetallic Ag3Sn was observed at the interface of the Cu/Ag/solder joint and Ni3Sn4 was found at the Cu/Ni/solder joint. In the case of Cu/Ni/Ag substrate, the layer sequence was observed to be Cu/Ni/Ni3Sn4/Ag3Sn/solder. The Ag layer was completely consumed by formation of Ag3Sn but the Ni layer remained. Environmental tests showed that the Cu/Ni/Ag substrate retained better solder joint reliability than either Ni or Ag single plated Cu substrate. Two types of reflow profiles were tested and the specimen reflowed by a higher temperature profile showed a higher solder joint strength. Solder joint strength and microstructural change were observed with several reflow cycles in considering the real board mounting conditions. There was significant evolution of solder and joint microstructures with reflow cycles and it explained well the change of solder joint strength.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
