Abstract
ABSTRACT Friction stir welding (FSW) process is widely used for joining Al-Cu alloy (AA2219-T87) plates because of its high joint efficiency and low residual stresses in contrast to fusion-based joining techniques. A two-way coupled, 3D thermal-material flow model has been developed in COMSOL software, and the effect of tool rotational speeds on thermal and material flow fields, strain rates, thermal histories, and size of weld zones are being studied. The non-uniform net heat generation during the FSW process is due to the friction between workpiece and tool materials and the deformation energy of plasticized material flow sheared by the rotating tool. An approximate range of temperatures for the weld zones has been proposed and found to be appropriate because the predicted sizes are in good agreement with the experiments. Furthermore, the authors suggested that a quality FSW joint must have the nugget zone smaller and the heat-affected zone larger than the tool shoulder diameter.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
