Effect of thermophoresis and other parameters on the particle deposition on a tilted surface

Abstract

In this study a modified version of v2-f turbulence model ( φ– α), is applied to simulate a non-isothermal air-flow. The φ- α model and a two-phase Eulerian approach complement each other to predict the rate of particle deposition on a tilted surface. The φ– α model can accurately calculate the normal fluctuations, which mainly represent the non-isotropic nature of turbulence regime near the wall. The Eulerian model was modified considering the most important mechanism in the particle deposition rate when compared to the experimental data. The model performance is examined by comparing the rate of particle deposition on a vertical surface with the experimental data in a turbulent channel flow available in the literature. The effects of lift force, turbophoretic force, thermophoreric force, electrostatic force, gravitational force and Brownian/turbulent diffusion were examined on the particle deposition rate. The results show that, using the φ– α model predicts the rate of deposition with reasonable accuracy. The results of modified particle model are in good agreement with the experimental data. This study highlights the paramount effect of thermophoretic force on the particle deposition rate and clearly shows that when the temperature difference exceeds a certain limit, the electrostatic force has insignificant effect on the particle deposition rate. Furthermore, it is indicated that even at small temperature differences, the effect of tilt angle on the particle deposition rate for intermediate-size particles is negligible.