Abstract
During the continuous casting of high-alloy (Mn, Al) steels, mold coating delamination occurs specifically at the narrow face (NF) mold corner immediately below the meniscus, different from where mold surface problems are generally known to occur. Most mechanical analyses have been performed assuming negligible thermal fluctuations and steady state interfacial heat fluxes. However, high-alloy steels exhibit larger thermal fluctuations than general steels during continuous casting, attributable to the reaction between the high-alloy steels and mold flux. Therefore, in this study, thermo-mechanical analyses are performed under both steady and fluctuating interfacial heat fluxes to compare the effects of thermal fluctuations on the continuous casting mold, with the results indicating that monotonic stresses are generated under steady interfacial heat fluxes at the corner of the NF mold, whereas cyclic stresses are induced by thermal fluctuations under fluctuating interfacial heat fluxes. Accordingly, the cyclic stresses at the corner of the NF mold, induced by thermal fluctuations, are determined as the major cause of mold coating delamination. These results can be applied to develop methods to reduce mold coating delamination, prevent the degradation of strand quality, and improve mold life.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Ironmaking & Steelmaking: Processes, Products and Applications
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
