Abstract
The use of crystal polystyrene for high performance components requires knowledge of the distribution of residual stresses. The aim of this research was to analyze the influence of the molding temperature and cooling time on the residual stresses present in parts of two types of crystal polystyrene PS1 and PS2, processed by injection molding. The results obtained using photoelasticity showed that at low temperatures the residual stresses increase due to the processes of formation and destruction of intermolecular forces. Internal stresses were reduced in the polymer specimens with greater thickness because the molecular relaxation of chains of polystyrene is facilitated by the space increase between the walls of the mold. It was concluded that the photoelasticity technique can be applied effectively in the measurement of residual stresses in injection molded crystal polystyrene parts.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
