Abstract
Predictive analysis of the life of an electronic package requires a sequence of processes involving: (i) development of a finite element (FE) model, (ii) correlation of the FE model using experimental data, and (iii) development of a local model using the correlated FE model. The life of the critical components is obtained from the local model and is usually compared to the experimental results. Although the specifics of such analyses are available in the literature, a comparison among them and against the same electronic package with different user printed circuit board (PCB) thicknesses does not exist. This study addresses the issues raised during the design phase/life analysis, by considering a particular package with a variable geometric thickness of the user PCB. In this paper, the effect of stiffening the user PCB on the fatigue life of a ball grid array (BGA), SAC305 solder joint is studied. The board stiffness was varied by changing the thickness of the PCB, while the size of the substrate, chips, and solder balls were kept constant. The test vehicle consisted of BGA chips soldered to a user PCB. The thickness of the user PCB was varied, but the surface area of the BGA chip remained identical. The test vehicle was then modeled using a finite element analysis tool (ANSYS). Using a global/local modeling approach, the modal parameters in the simulations were correlated with experimental data. The first resonance frequency dwell test was carried out in ANSYS, and the high-cycle fatigue life was estimated using the stress-life approach. Following the simulation, the test vehicle was subjected to resonance fatigue testing by exciting at the first mode resonance frequency, the mode with the most severe solder joint failure. The resistance of the solder joint during the experiment was monitored using a daisy-chain circuit, and the point of failure was further confirmed using the destructive evaluation technique. Both the experimental and simulation results showed that stiffening the board will significantly increase the fatigue life of the solder joint. Although the amplitude of the acceleration response of the test vehicle will be higher due to board stiffening, the increase in natural frequencies will significantly reduce the amplitude of relative displacement between the PCB and the substrate.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
