Effect of Si on the deformation behavior of retained austenite and annealed martensite in medium Mn steels

Abstract

The present study systematically investigated the effect of Si additions from 0 to 4 wt % on the deformation mechanism of a Fe-0.2C-6.8Mn (wt. %) medium Mn steel. The duplex microstructure consisting of film-like retained austenite (RA) and lath-shaped annealed martensite (AM) was produced for different Si alloyed steels by annealing treatments. They have similar volume fraction of RA. The effect of Si content on the dynamic strain aging (DSA) of RA and the serration type of tensile curves, as well as the fine structure evolution within AM during deformation was studied in detail. For the different Si alloyed steels, their tensile curves all exhibit flow serrations, accompanied with the propagation of the Portevine-Le Châtelier (PLC) band caused by DSA in RA. The serration type was sensitive to Si content. For the high Si steel, only type B serrations appear. This is attributed to the high Si content in RA, promoting aged dislocations by C atoms due to the repulsive interaction between C and Si atoms. For the low Si and Si free steels, type A serrations occur after type B serrations disappear at a certain strain. The mechanical stability and Mn/Si contents of RA play an important role in the PLC band propagation. The Si content has also an important effect on the evolution of dislocation configuration within AM during deformation. In the low and Si free steels, the dislocation multiplication and tangles, as well as the formation of dislocation walls, dividing up the laths appear in the AM. While in the high Si steel, it is found that the dislocation cells appear within the AM due to Si addition promoting the formation of screw dislocations by neutron diffraction technique, and the cross slip of screw dislocations as a necessary mechanism for dislocation cell formation. The formation of dislocation configuration with low energy is believed to be another essential factor improving the mechanical properties, besides the transformation-induced plasticity effect. This work paves a new pathway towards tailoring dislocation configuration for designing a new generation advanced high-strength steel.