Abstract
The purpose of this study was to evaluate the effect of a resin coating technique on the microtensile bond strength (microTBS) of resin cement to dentin in composite crown restorations. Crown preparations were done on human molars. A resin coating material, Hybrid Bond, was immediately applied to the prepared dentin and light-cured, while the tooth without resin coating acted as the control. An impression of the resin-coated tooth was taken, and a composite crown fabricated on the working cast. The composite crown was then bonded with a resin cement, Chemiace II. MicroTBSs were measured at a crosshead speed of 1 mm/min, and the resin-coated group yielded significantly higher microTBSs than the non-coated group (p < 0.05). In terms of microTBS values between the axial and occlusal surfaces, no regional differences in resin-dentin bond strength were detected (p < 0.05). It was concluded that resin coating with Hybrid Bond significantly improved the microTBS of resin cement to dentin in composite crown restorations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.