Abstract
Mechanical, piezoelectric and dielectric properties of PZT ceramics (Pb 0.98M 0.02[(Zr 0.535Ti 0.465) 0.995]O 3, M=Er, Gd, Eu, Nd, La and Bi) have been studied. The fraction of A sites occupied by the different additives is estimated and is found to increase with the ionic radius of the additive ion. The density is high in Bi-, Gd- and Eu-PZT samples. Small amounts of the pyrochlore phase are present in Gd- and Eu-PZT. A maximum strength of 80–100 MPa and K IC of ∼1.5 MPa m 1/2 are obtained in Gd- and Eu-PZT. The R-curve behavior becomes more pronounced in Gd- and Eu-PZT, and it is observed that the strength and K IC increase with the slope of the K IC versus c 1/2 plot. Very good piezoelectric properties, i.e. d 33 of 410 PCN −1, dielectric constant of 1005, κ p of 0.49 and the hydrophone figure of merit, d h g h, of 2760 are obtained for Nd-PZT. The piezoelectric properties in Bi-PZT are also higher than for the undoped composition, while for the Gd-PZT, these are slightly inferior. For all other compositions, the piezoelectric properties are not affected much.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.