Abstract
Effect of printing layer thickness on technological properties of 3D-printed specimens fabricated from wood flour/PLA filaments having a diameter of 1.75 mm was investigated. For this aim, four different printing layers, 0.05 mm, 0.1 mm, 0.2 mm, and 0.3 mm, were used in the production of the 3D-printed specimens. The water absorption of the specimens (28 days immersion in water) increased with increasing printing layer thickness while the thickness swelling decreased. The tensile and bending properties of the specimens significantly improved with decreasing printing layer thickness. The increase in the layer thickness caused bigger gaps, which increased the porosity in the cross section of the specimen. Higher porosity resulted in lower mechanical properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.