Abstract
Dissimilar metal joining of Ti–6Al–4V (TC4) titanium alloy to as-rolled 40Cr steel rods was conducted with friction welding, and the effect of post-weld heat treatment (PWHT) on the microstructure and mechanical properties of the resultant joints was investigated. The average tensile strength of the as-welded joints reached 766 MPa and failure occurred in 40Cr steel base metal. However, after PWHT at 600 °C for 0.5, 1, 2 and 3 h, the tensile strength of the joints decreased and fracture happened through the interface with quasi-cleavage features. The bending angle of specimens was improved from 9.6° in as-welded state to 32.5° after PWHT for 2 h. The tensile strength of the joint was enhanced by martensitic transformation near the interface in as-welded state. Sorbite formed near the interface in PWHT state and improved the bending ductility of the joint. TiC brittle phase formed at the interface after PWHT for 0.5 h and deteriorated the tensile strength and bending ductility of the joint. After PWHT for 2 h, no TiC phase was detected at the interface. The microhardness on the interface in as-welded state was higher than that after PWHT, indicating that the decrease of microhardness around the interface could be accompanied by degradation of tensile strength but improvement of bending ductility of the joints.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
