Abstract
An abrasive free chemical mechanical planarization (AFCMP) of semi-polar (112¯2) AlN surface has been demonstrated. The effect of slurry pH, polishing pressure, and platen velocity on the material removal rate (MRR) and surface quality (RMS roughness) have been studied. The effect of polishing pressure on the AFCMP of the (112¯2) AlN surface has been compared with that of the (112¯2) AlGaN surface. The maximum MRR has been found to be ~562 nm/h for the semi-polar (112¯2) AlN surface, under the experimental conditions of 38 kPa pressure, 90 rpm platen velocity, 30 rpm carrier velocity, slurry pH 3 and 0.4 M oxidizer concentration. The best root mean square (RMS) surface roughness of ∼1.2 nm and ∼0.7 nm, over a large scanning area of 0.70 × 0.96 mm2, has been achieved on AFCMP processed semi-polar (112¯2) AlN and (AlGaN) surfaces using optimized slurry chemistry and processing parameters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
