Abstract
The cold spray process usually involves preheating particle and increasing particle impact velocity to improve the deposition efficiency. In the present study, the effect of particle and substrate preheating on the deformation behavior of cold sprayed particle was investigated using the Eulerian formulation available in software of ABAQUS/Explicit with typical copper material. Preheating ways were used by realizing different temperatures on the substrate, particle and both. Calculated results show that different preheating ways result in different deformation patterns, the flattening ratio and compression ratio of Cu particle and the maximum equivalent plastic strain. Preheating whole model, substrate and particle shows a coordinated deformation pattern, penetration way and spreading way, respectively.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
