Abstract

ABSTRACTThe effect of moisture content on the linear viscoelastic properties of gliadin hydrated to 30 and 40% moisture content [gliadin(30%) and gliadin(40%), respectively] was determined. These two moisture contents bracketed the equilibrium moisture content of gliadin, which was 37.6%. Time‐temperature‐superposition was used to develop master curves of the elastic modulus (G′), viscous modulus (G″), dynamic viscosity (η′), and tan δ (G″/G′) from isothermal frequency sweep data obtained at 25–80°C. Smooth master curves were obtained for all of the viscoelastic functions for both gliadins. G′ and G″ showed a power law dependency on frequency (with G″ > G′) for frequencies <0.1 rad/sec for gliadin(30%) and <1 rad/sec for gliadin(40%). The low‐frequency‐limiting slopes on log‐log coordinates for G′ and G″ were 0.700 and 0.646 for gliadin(30%), respectively. Corresponding values were 0.658 and 0.614 for gliadin(40%). G′ crossed over G″ at a frequency of ≈0.3 rad/sec for gliadin(30%), while G′ and G″ for gliadin(40%) only became congruent at higher frequencies. Both gliadin samples showed appreciable frequency dependence of η′ over the entire frequency range, while η′ was greater for gliadin(30%) than for gliadin(40%) at all frequencies, but especially at the lowest frequencies. Tan δ increased gradually from a value of ≈1 at 0.1 rad/sec to ≈2 at the lowest frequency of 0.0002 rad/sec for both gliadins, but tan δ decreased rapidly for gliadin(30%) for frequencies >0.1 rad/sec. Thus, the main difference between gliadin(30%) and gliadin(40%) was that elastic effects (G′ > G″ and decreased tan δ were more prominent for gliadin(30%) at the higher frequencies. In addition, the frequency dependence of G′, G″, η′, and tan δ for the two gliadin samples was compared directly with two samples of poly(dimethylsiloxane) (PDMS) a linear silicone‐based entangled polymer with molecular weights (MW) of 140,000 and 385,000. The substantial differences in the magnitude and overall patterns of the frequency dependence of the viscoelastic functions between the gliadin and PDMS samples was attributed to the dominant effect that noncovalent secondary associations apparently have on the linear viscoelasticity of the gliadins. The energy of activation for flow (determined from the temperature dependence of the shift factors) for the gliadin samples for the range 25–45°C was higher than is typical for entangled linear polymer melts. The activation energy decreased for temperatures greater than ≈60°C for gliadin(30%) and ≈50°C for gliadin(40%). Thus, hydrated gliadin cannot be considered to be a simple viscoelastic liquid.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.