Abstract
In this study, a simple thick‐film humidity sensor was fabricated by coating wet‐synthesized ZnO nanorods on screen‐printing interdigitated electrodes. We investigated the influence of the coating procedure on the microstructure of ZnO nanorod films and thereby on humidity sensing. The experimental results revealed that the specific surface area (SSA) decreased and the average pore size (APS) increased with increasing the sintering time and the number of coating layer. The humidity response depended significantly on the pore properties of the ZnO nanorod films. By virtue of the incipient wetness analysis, it was found that the adsorption of water molecules on the ZnO surface led to the decrease in electrical resistance even though the ZnO was rod like, n‐type semiconductor. While tuning the pore structure of the ZnO nanorod film, the thick‐film humidity sensor might display near‐linear response in the full range of 0%–100% relative humidity (RH).
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
