Abstract
The effect of applied load on the wear behaviour of polymer matrix composites produced using carbonized bone particles (CBp) as reinforcement has been studied. The addition of the CBp ranges from 5 to 20 wt% in the polypropylene matrix. The composites were produced by compounding and compressive moulding. The wear test was conducted by varying the applied load from 5 to 15 N. Microstructures of the worn surface were assessed with high resolution scanning electron microscopy (HRSEM/EDS). The wear rate increased with increases in applied load from 5 to 15 N and decreased with increasing in CBp from 0 to 15 wt%. The work has established that carbonized bone can be use in increasing the wear resistance of polypropylene composites.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
