Abstract
Based on the fretting wear failure of key parts of short stress line rolling mill, selective laser melting was chosen to repair the failure parts. The effect of laser scanning rate on microstructure, hardness and wear resistance of cladding layer was studied. The results show that the microstructure of the cladding layer is mainly lamellar martensite with a little retained austenite and carbide. The hardness of the cladding layer increases with the increase of scanning rate and the decrease of energy density. The maximum hardness is about 950 HV0.2. The friction coefficient of the cladding layer varies little with different laser scanning rate. The wear rate of the cladding layer increases firstly and then decreases with the increase of laser scanning rate. The wear rate of the sample with scanning rate of 6 mm/s is the smallest, which is 2.0466•10-5 mm3/(N·m) .
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
