Abstract
Composite sheet of Twin Roll Cast (TRC) AZ31-Mg alloy and industrial pure Al-1050 was fabricated as Al/Mg/Al with a hot roll bonding process. As the diffusion zone at the interface between the layers plays a crucial role in the formation of bonding strength and formability of clad sheets. It is important to describe the processes of inter-diffusion layer generation in order to assess the abilities of the laminate composites for further processing. Thus, the aim of this study was to investigate the development of the bonding strength, microstructure and mechanical properties of the bonding interface directly after roll bonding and additionally post-annealing processes. Microstructure characterization techniques such as optical and scanning electron microscopy including energy dispersive X-ray analysis (EDX) were applied to investigate the bonding area. No inter-metallic phases were present directly after the roll bonding process. The creation and growth of Al2Mg3 and Al12Mg17 phases were apparent after annealing at temperatures of 250 to 400 °C at different times ranging from five to 120 minutes. The results prove that the growth rate of inter-metallic phases increases considerably with an increase in the annealing temperature. The micro-hardness of the interface-area was also investigated. It was observed that the two inter-metallic phases were significantly harder than the substrate Mg and Al. In order to examine the influence of the inter-metallic phases on the resulting bonding strength after the annealing process, the shear bonding strength test has been conducted for different samples that were annealed at different heat treatment conditions. The results indicate that the optimum annealing temperature is 200 °C leading to a maximum bonding strength. Moreover, the mechanical properties of the composite after roll bonding and post annealing were determined by means of room temperature tensile test. The fracture mechanism after tensile test was also discussed.Keywords:Rollbonding,Al/Mghotrollbonding,TwinrollcastAZ31,bondingstrength
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
