Effect of insoluble dietary fiber on printing properties and molecular interactions of 3D-printed soy protein isolate-wheat gluten plant-based meats

Abstract

Insoluble dietary fiber (IDF) has been characterized to prevent chronic diseases and improve gastrointestinal health, and it has been added to 3D printing plant-based meats (PM) to enhance texture and increase nutritional properties. Therefore, the aim of this study was to investigate the effects of IDF on 3D printing properties and molecular interactions of soy protein isolate (SPI) - wheat gluten (WG) PM. Without the participation of IDF, PM appeared to collapse. When the IDF concentration increased from 0 to 10 %, PM displayed good printing properties, water holding capacity, tensile strength, and elongation at break were increased. Tensile strength and elongation at break reached a maximum at 10 % IDF, and clearly similar results were found for texture attribute indices such as hardness, gumminess, chewiness, and cohesiveness after cooking. All printing inks exhibited shear-thinning behavior and solid-like viscoelasticity, but the structural recovery properties of 3D-printed PM deteriorated when the IDF content was over 10 %. Intermolecular forces indicated that the addition of IDF enhanced the disulfide bonds so that 10 % IDF presented better printing properties. These results indicated the potential for developing PM with dietary fiber functionality through 3D printing technology.