Abstract
Different film thickness was used to investigate the effect of the Al2O3 as a dielectric material for the fabrication of Al/AL2O3/Si/Al MOS diode. Chemical spray pyrolysis method was employed in this work. A high rectification behavior was observed from current-voltage (I-V) measurements in forward and reverse in dark. Optimum ideality factor of (2.36) at 5 sprayed layers was observed, the breakdown voltage found to be 5 MV cm−1 while the barrier height was (0.65 eV) at the same layer thickness. Capacitance-voltage (C–V) measurements was carried out which ensure the formation of abrupt junction; the incorporating built-in potential (Vbi) was estimated and found to be (0.8 eV). In addition, the photodiode shows a good Responsivity of about (1.4, 1.8) Amp/watt at Uv and IR region respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.