Abstract

We consider dynamic motions of a spatial robot suspended by six cables, arranged so as to form three parallelograms. Each parallelogram is composed by two parallel cables sharing the same length. Due to this arrangement, the end-effector can only translate. The cables in each parallelogram can be actuated by one motor: only three motors are then required, which reduces the robot complexity and cost. This robot may perform pick-and-place operations over large workspaces. We find tight conditions for feasibility of dynamic trajectories for the general architecture, and also special conditions such that the robot is dynamically equivalent to a 3-cable robot with a point-mass end-effector: then, the feasibility conditions previously developed for the dynamic trajectories of 3-cable point-mass robots can be profitably reused for the present case. To practically realize such dynamic trajectories, we also analyze the reachable, singularity-free and interference-free workspace, finding analytical expressions of their loci. Finally, we perform experiments where the robot follows dynamic trajectories outside its static workspace, thus finding confirmation that the orientation remains approximately constant.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.