Abstract

Limitations in our ability to produce two responses at the same time – that is, dual-task interference – are typically measured by comparing performance when two stimuli are presented and two responses are made in close temporal proximity to when a single stimulus is presented and a single response is made. While straightforward, this approach leaves open multiple possible sources for observed differences. For example, on dual-task trials, it is typically necessary to identify two stimuli nearly simultaneously, whereas on typical single-task trials, only one stimulus is presented at a time. These processes are different from selecting and producing two distinct responses and complicate the interpretation of dual- and single-task performance differences. Ideally, performance when two tasks are executed should be compared to conditions in which only a single task is executed, while holding constant all other stimuli, response, and control processing. We introduce an alternative dual-task procedure designed to approach this ideal. It holds stimulus processing constant while manipulating the number of “tasks.” Participants produced unimanual or bimanual responses to pairs of stimuli. For one set of stimuli (two-task set), the mappings were organized so an image of a face and a building were mapped to particular responses (including no response) on the left or right hands. For the other set of stimuli (one-task set), the stimuli indicated the same set of responses, but there was not a one-to-one mapping between the individual stimuli and responses. Instead, each stimulus pair had to be considered together to determine the appropriate unimanual or bimanual response. While the stimulus pairs were highly similar and the responses identical across the two conditions, performance was strikingly different. For the two-task set condition, bimanual responses were made more slowly than unimanual responses, reflecting typical dual-task interference, whereas for the one-task set, unimanual responses were made more slowly than bimanual. These findings indicate that dual-task costs occur, at least in part, because of the interfering effects of task representation rather than simply the additional stimulus, response, or other processing typically required on dual-task trials.

Highlights

  • In daily life, we must often process multiple stimuli and make multiple responses in close temporal proximity, which often produces a substantial decrease in performance on one or more of the tasks performed

  • Because this research involves the effects of task representations – and these representations must be learned (Wilson and Niv, 2012) – we had participants practice the conditions over three experimental sessions so that we could be confident that their task representations were stable before we investigated the effect on dual-task interference

  • The critical test for the effect of task representation on dual-task processing is in Session 3, once participants had learned the tasks

Read more

Summary

Introduction

We must often process multiple stimuli and make multiple responses in close temporal proximity, which often produces a substantial decrease in performance on one or more of the tasks performed This so-called multi-task (or dual-task) interference has been the subject of a large number of studies over the past 50 years (for review see Pashler, 1994). A popular procedure for studying dual-task interference is the psychological refractory period (PRP) procedure (e.g., Welford, 1952; Pashler, 1984) This procedure involves varying the stimulus-onset asynchrony (SOA) between stimuli associated with two distinct S–R mapping sets (tasks) and measuring the decrease in task performance as SOA decreases. The PRP procedure has been a useful technique for identifying the locus of dual-task interference when it exists (McCann and Johnston, 1992; Schumacher et al, 1999) – in response selection processes (i.e., the mental operations that associate task-related responses to current stimuli)

Methods
Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.